Cutting Out The Spaces
In cutting out the intervening spaces, which should be done with a sharp chisel, care should be observed not to cut over the shoulder lines. To prevent mistakes you should put some distinctive mark on each part to be cut away. In this instance E, H show the parts to be removed, and in Fig. 48 two of the cutaway portions are indicated.
When the end of the board Z is turned up (Fig. 49), it has merely the longitudinal parallel lines B. The bevel square may now be used in the same manner as on the side of the board Y, and the fitting angles will then be accurately true.
This is shown in Fig. 50, in which, also, two of the cutaway parts are removed.
Next:
Tools Used In Laying Out Tenons And MortisesPrevious:
First Steps
Viewed 330
Informational
