Applying Molding





Let Fig. 197 represent the front, top and bottom of our cabinet; and the first thing we shall do is to add a base (A) and a cap (B). Now, commencing at the top, suppose we utilize the simplest form of molding, the band.

This we may make of any desired width, as shown in Fig. 198. On this band we can apply the ogee type (Fig. 199) right side up.

But for variation we may decide to use the ogee reversed, as in Fig. 200. This will afford us something else to think about and will call upon our powers of initiative in order to finish off the lower margin or edge of the ogee reversa.

Fig. 197. Fig. 197.


























Fig. 198. Fig. 199.
Fig. 198. Fig. 199.




If we take the ogee recta, as shown in Fig. 201, we may use the cavetto, or the ovolo (Fig. 202); but if we use the ogee reversa we must use a convex molding like the cavetto at one base, and a convex molding, like the torus or the ovolo, at the other base.

In the latter (Fig. 202) four different moldings are used with the ogee as the principal structure.





Angles For Holding Planes Base Embellishments facebooktwittergoogle_plusredditpinterestlinkedinmail

Feedback