Simple Saw Setter





Take a block of wood, a 4 by 4 inch studding, four inches long. Get a piece of metal one-half inch thick and two inches square. Have a blacksmith or machinist bore a quarter-inch hole through it in the center and countersink the upper side so it may be securely fastened in a mortise in the block, with its upper side flush with the upper surface of the block. Now, with a file, finish off one edge, going back for a quarter of an inch, the angle at A to be about 12 degrees.

Fig. 13. Rip-Saw Fig. 13. Rip-Saw






Signs To Indicate Measurements Simple Turning Lathe facebooktwittergoogle_plusredditpinterestlinkedinmail

Feedback