Tools Used





The back saw is used for cutting the tenon, and the end of the board appears as shown in the enlarged Fig. 34. Two things are now necessary to complete the tenons. On the upper or work edge of each board use the gage to mark off a half-inch slice, and then cut away the flat side of the tenon at the end, on its inner surface, so it will appear as shown in Fig. 35.

Fig. 36. Fig. 36.


Fig. 37. Fig. 37.






Tie Beam Tools Used In Laying Out Tenons And Mortises facebooktwittergoogle_plusredditpinterestlinkedinmail

Feedback