Magazine Stand





Stand Complete Stand Complete


If you do not possess the necessary tools for getting out the material used in this piece of furniture, it can be purchased from a mill already planed, sanded and cut to lengths given in the list. Any kind of wood can be used, but quarter-sawed red oak with a mission stain and waxed, gives the best appearance. The following pieces will be needed:





  • 2 shelves, 3/8 by 8 by 15 in., S-2-S.


  • 1 shelf, 3/8 by 10 by 15 in., S-2-S.


  • 1 shelf, 3/8 by 12 by 15 in., S-2-S.


  • 8 slats, 3/8 by 1-1/8 by 38 in., S-4-S.


  • 2 slats, 1/4 by 1-1/8 by 38 in., S-4-S.


  • 4 doz. 1 in. No. 9 round-head screws.




[103]



Take the four shelves and line them up with their backs and ends even and clamp them together firmly. Mark the places for the slats across the edges of the shelves, making the first line 1/2 in. from their ends. Use a square to get the lines at right angles to the surface. Another line is drawn 1-1/8 in. from the first, or the width of the slat. The ends of the shelves are marked in the same manner, beginning from the back edges and making the first line 1/2 in. from them, and then another line 1-1/8 in. from the first, or the width of the slat. Make a line across the ends, [104] 1/2 in. from the front edge of the 8-in, shelves, and another line 1-1/8 in. back from the first one. This will leave 2-1/2 in. and 4-1/2 in. of space respectively from the front edges of the 10-in. and 12-in. shelves. Shift the shelves so they will be even on the front edges and mark them the same as the back. Make a 1/4-in. depth mark on all edges between the lines and cut this material out. This can be done while the shelves are clamped together.



Detail of Stand Detail of Stand


[105]



Place the shelves on end in their order and start by screwing on the back slats on both ends first, then screw on the two front slats. Turn the stand down and put on the two back slats. Attach the two front slats on the top shelf first. Then bore the places for the remaining holes and turn in the screws. This will bend the slats into place. The two remaining slats are screwed on the ends of the shelves without letting them in, making the spaces equal. Mark each slat 1/2 in. below the bottom shelf and saw them off. The stand can be taken apart, sandpapered and stained.







Magazine Rack Mission Stains facebooktwittergoogle_plusredditpinterestlinkedinmail

Feedback