Sawing For The Recess





After marking out for the hinge, as shown at , take a fine-toothed saw (a dovetail saw is considered the best) and saw down as shown at , care being taken not to cut beyond the gauge lines. In this sketch three intermediate saw kerfs are shown, but if the hinge is of great length, say 5 or 6 ins., the removal of the waste wood will be greatly facilitated by the addition of more intermediate saw kerfs. These cuts sever the cross fibres and allow the timber to be easily pared away in short lengths.



In we see the tool operation when paring out the hinge recess. At the left of the drawing the recess is shown marked. Take a 3⁄4 in. chisel and, using it as a knife (see A), deepen the gauge lines. Then stab the chisel downwards, as at B, to deepen the end lines. Next, take the chisel and pare away the back of the recess as at C. The work may then be completed by paring neatly till the bottom of the recess is flat.

















Fig. 227.

Fig. 227.

Fig. 228.

Fig. 228.



The Hingeing of a Box Lid.







Sawing Block Sawing The Dovetails facebooktwittergoogle_plusredditpinterestlinkedinmail

Feedback