Tongueing





The grooves having been completed, the tongues have to be made. shows a sketch of a board and the method of marking out cross tongues (A) and feather tongues (B). The usual procedure for making cross tongues is to plane the end of the board and use a cutting gauge to give a line the required distance from the end (see sketch). The board is sawn with a tenon or panel saw, and the piece of timber for the tongue is thus procured. If a feather tongue is to be used it is cut diagonally from the board (B) and the ends cut square as shown by the dotted line.



Fig. 123.—Method of Marking Out for Cross Tongues  and Feather Tongues. Fig. 123.—Method of Marking Out for Cross Tongues and Feather Tongues.


Feather tongues can be obtained in fairly long lengths out of narrow boards, whilst on the other hand cross tongues are limited by the width of the board. After cutting off the tongues, they require planing with nicety to fit the grooves, and the advantage of a grooved board will be appreciated. A glue spoon similar to a plumber's ladle is generally used to pour the glue into the grooves, and it is customary to glue the tongue into one board first; after allowing this to set, the joint is completed in the usual manner.







To Set Out A Curved Mitre Tongueing Planes facebooktwittergoogle_plusredditpinterestlinkedinmail

Feedback