The Try Square
In the use of the ordinary large metal square it is necessary to lay the short limb of the square on the face of the work, and the long limb must, therefore, rest against the work side or edge of the timber, so that the scribing edge of the short li... The Vertical Upright Truss
This form of truss naturally develops into a type of wooden bridge known all over the country, as its framing is simple, and calculations as to its capacity to sustain loads may readily be made. Figs. 237, 238 and 239 illustrate these forms. <div> ... The Warren Girder
Out of this simple truss grew the Warren girder, a type of bridge particularly adapted for iron and steel construction. This is the simplest form for metal bridge truss, or girder. It is now also largely used in steel buildings and for other work re... The Work Bench
In its proper place we show in detail the most approved form of work bench, fitted with a tool rack to hold all the tools, conveniently arranged. In this chapter we are more particularly concerned with the uses of tools than their construction; and ... Tie Beam
See Queen Post. ... Tools Used
The back saw is used for cutting the tenon, and the end of the board appears as shown in the enlarged Fig. 34. Two things are now necessary to complete the tenons. On the upper or work edge of each board use the gage to mark off a half-inch slice,... Tools Used In Laying Out Tenons And Mortises
A sharp-pointed knife must always be used for making all marks. Never employ an awl for this work, as the fiber of the wood will be torn up by it. A small try square should always be used (not the large iron square), and this with a sharp-pointed c... True Mortise Work
The essense of good joining work is the ability to sink the chisel true with the side of the member. More uneven work is produced by haste than by inability. The tendency of all beginners is to strike the chisel too hard, in order the more quickly... Trusses
There should be at least two, each three feet in length and twenty inches in height. ... Use Of Stains
Our subject has nothing to do with the technique of staining, but has reference, solely, to the use of stains. I recommend, therefore, that, since all kinds of stains are now kept in stock, and for sale everywhere, you would better rely upon the man... Wall Headers
When all the studding are in you will need headers above and rails below the windows and headers above all the doors, so that you will have timbers to nail the siding to, as well as for the lathing. ... What Degrees Are Calculated From
The question that now arises is what line one may use from which to calculate degrees, or at what point in the circle zero is placed. Degrees may be calculated either from the horizontal or from the vertical line. Examine Fig. 53. The working margi... Where Mortises Should Be Used
Most important of all is a general idea of places and conditions under which mortises should be resorted to. There are four ways in which different members may be secured to each other. First, by mortises and tenons; second, by a lap-and-butt; thir...

Roofing Trusses The Roman-doric Column Saddle Joint Proportional Dividers The Warren Girder Soft Woods The Hatchet Saw Clamps

The &quot;odd Job&quot; Tool Great Contrasts Bad Where Mortises Should Be Used Front And Side Lines Hard Wood Imitations Polishing Stained Surfaces The Carpenter And Architech Forcing Saws In Wood