In selecting or making up mission furniture for the home, a screen is necessary sometimes to add to the appearance of a room. The screen shown in the accompanying illustration consists of a few parts which are easily put together. The stock can be bought of any planing mill planed, sanded and cut to the proper lengths. The cloth, which should be of dark color, can be purchased at a dry goods store. The following list of material will be needed.
Cut or plow a groove 1/4 in. wide and 1/4 in. deep in the center of one surface on each of the 3/4-in. rails. Cut out the ends with a compass saw. The five holes are bored with a 1-in. bit. The edges  of these panels are inserted in the grooves of the 3/4-in. rails, using plenty of good glue.
When the glue has dried for at least 24 hours the screen frame can be put together. Holes for the screws should be bored through the posts where the 3/4-in. rails are joined and a screw turned into the end grain of each rail.
Scrape off all the surplus glue and sandpaper all the parts well. When this is done the finish can be applied. Any one of the mission stains can be used and finished with wax and polished.
The cloth is cut to length, a hem sewed on each end and one 1/2-in. rail put through each hem. Place the top rail in position and screw it fast. Stretch the cloth tight and fasten the lower 1/2-in. rail with screws at the bottom. Each section of the screen is finished in the same way.
The hinges are attached about 4 in. from each end of the posts in the same manner as hanging a door. 
The sections can be made up in various ways to suit the builder. Instead of using cloth, heavy paste-board, or board made up to take the place of plaster on walls of dwellings, may be substituted, thus forming a ground that will take paint and bronze decorations. A piece of this material can be easily cut to fit the opening in each section.